ATOS ScanBox 6130

Open automated 3D metrology system

ScanBox 6130 is an open automated 3D solution from GOM. With the rotation table placed centrally in the housing, combined
with a long-reaching robot, even large and complex parts can easily be measured.

The system has been designed without doors to facilitate easy loading of parts. A light sensor ensures that the robot stops, if the scanning area is entered.

ATOS ScanBox 6130 uses the ATOS Triple Scan 

 

ATOS ScanBox 6130 with car part

Speed and precision
A fully automatic metrology system optimizes your part verification and quality control. When the scanning process has been programmed, the 3D scanning will run its course without operator involvement. This ensures an increased output in a shorter timespan.

The automated calibration process is integrated in the system. This provides a better operator workflow and ensures a correct setup, thus securing precise measurements each time.

ATOS ScanBox 6130 is an ideal solution for part verification and continuous quality control in the production. It is also a valuable asset in the product development phase, and testing of large tools. Warpage, shrinkage and displacements are easily identified and analyzed. 

ATOS ScanBox 6130
Dimensions 4250 x 4250 x 2700 mm
Power supply 200-500 V (3-phase, 16 A)
Max. part size Ø 3000 mm
Max. part weight Up to 2000 kg
Automated axes 7
Entry Light sensor
Entry width 3100 mm
Floor mounting Yes
Loading concept Manual, crane, truck

Contact

Jeppe H. Laursen
CEO

+45 4196 4955
jhl@zebicon.com

Danish distributor

Zebicon is the danish distributor of 3D measurement systems by GOM, who is developing and producing high precision metrology solutions.  

Read about GOM